Hitec HS-645MG

  • Model: HT-HS-645MG
  • 2 Units in Stock

AUD$59.99

Add to Cart:

 

 The HS-645MG is one of our favorite servos of all time. We use this servo for all types of robotic applications and industrial products. The reliability and performance that you get  is fantastic. Metal gears, dual ball bearings, seperated motor and circuit board make the HS-645MG a top choice whether your project is robotics, aircraft, cars or trucks. 

 

Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.24sec/60° at no load
Operating Speed (6.0V): 0.20sec/60° at no load
Stall Torque (4.8V): 106.93 oz/in. (7.7kg.cm)
Stall Torque (6.0V): 133.31 oz/in. (9.6kg.cm)

Operating Angle: 45 Deg. one side pulse traveling 400usec

Continuous Rotation ModifiableYes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8.8mA/idle and 350mA no load operating
Current Drain (6.0V): 9.1mA/idle and 450mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Indirect Drive 
Bearing Type: Dual Ball Bearing
Gear Type: 3 Metal Gears and 1 Resin Metal Gear
Connector Wire Length: 11.81" (300mm)
Dimensions: 1.59" x 0.77"x 1.48" (40.6 x 19.8 x 37.8mm)
Weight: 1.94oz. (55.2g)

 

 

Your IP Address is: 44.199.241.53
Copyright © 2024 XC-RC.com.au. Powered by Zen Cart