MT-HS -100A-HV-OPTO- V1, 12S

  • Model: MT-HS-100A-HV-OPTO-V1
  • 4 Units in Stock

AUD$178.00

Add to Cart:

MT100A- HV -OPTO (6s-12s) is a 100A brushless speed controller that can handle a maximum current burst of 120A.

Its performance in terms of compatibility, reliability and stability can compete with world famous brands.

Features:

  • Support High RPM motors.
  • Circle menu setting is simple.
  • Power arming protection:
  • Prevents the motor from accidentally running when switched ON
  • Lost Throttle signal protection:
  • The ESC will automatically reduces output power to the motor when it detects a lost of throttle signal for 1 second. A subsequent loss of throttle signal beyond 3 seconds will cause the ESC automatically to cut power to the motor.
  • Safety thermal over-load protection:
  • Automatically reduce output power to half when the temperature reaches 110℃, restore output power when the temperature is below 110℃.
  • Can continuously provide power to the motor.
  • Acceleration: Provides quick acceleration start ups with a linear throttle response.
  • Governor Mode: For Helicopter application
  • With latest humanize software design, especially for all types of brushless motor.
  • New advanced programming software.

Functions: 

  • Brake Setting: on/off
    Note:Factory default setting: off. 
  • Battery type: LiPo /NiMh/NiCad
    Note: Factory default setting: 3 Li- Poly 
  • Under voltage protection (Low voltage cutoff type): 

Reduce power:

  • Reduce motor speed to half throttle
  • Cut off: Stop motor immediately
  • Ignore: Motor won't stop until battery totally gone)
    Note: Factory default setting: Reduce power 
  • Soft start (Acceleration): very soft/ soft/ start acceleration
    Note. Factory default setting: Soft start: Enable 

Timing:

  • Automatic: (7-30 degree)
  • Soft: (7 -22 degree)
  • Hard :( 22-30 degree)
    Note. Factory default setting: Automatic 
  • Frequency: 8 KHz/ 16 KHz, Factory default setting: 8 KHz 
  • Heli Governor Mode: Factory default setting: rpm control off  
  • 120A Max Current Burst. No Bec . Requires separate receiver pack to run servos.
  • Input Voltage: 5-12sLipo or 16-36cells NiCD.            
    Net Weight : 89g
    Dimensions: 41.5x 37.5 x`9.5 mm
     
    The MAYTECH  Harrier Supreme ESC's are extremely well built. Sure to satisfy any discerning Modeller.  Maytech speed controllers can be programmed by transmitter or quickly and easily by using Maytech TS programming card.
Your IP Address is: 18.234.139.149
Copyright © 2024 XC-RC.com.au. Powered by Zen Cart