MTA-70A-LV-OPTO

  • Model: MTA-70A-LV-OPTO
  • 0 Units in Stock

AUD$72.99

Sold Out

MTA-70A-LV-OPTO( no bec) is a 70A brushless speed controller which can handle a maximum burst current of 90A . Specifically for Aircraft/ Gliders

 

Features:

  • Easy setting, easy operation.
  • Excellent Throttle Linearity and Response
  • Separate  voltage regulator IC for MCU which gives it high anti-interference properties
  • Safe start-up system:
  • The motor won't be started no matter which position the throttle stick is on when the battery is connected.
  • Automatic power cut-off:
  • When the motor stops rotating or the radio signal loses for more than 3 seconds, the power will automatically be cut off.
  • High rate switching Pulse Width Modulation (PWM): 8KHz.
  • Over-heat protection:
  • The power will be cut-off as it is heated up to 110?.
  • Over-voltage protection:
  • The motor won't be started if the voltage is higher than 18V.
  • Low-voltage cut-off:
    • 3.0V/2.7V (selectable) for Li-ion/Li-polymer battery.
    • 0.9V/0.7V (selectable) for Ni-CD/Ni-MH battery.

Timing mode:

  • Timing low mode----providing highest efficiency suitable for motors with 2, 4, 6 poles.
  • Timing high mode----providing highest rotation speed & biggest current suitable for motors with 6 or more poles and outrunning motors.
  • Programming Card: AS to be used for setting ESC
  • Programming can be done on the programming board easily.

Factory Default Setting:

  • Brake off.
  • Timing high
  • For outrunning motors and motors with more than 6 poles.
  • Throttle curve
  • Linear.

Battery type

  • Li-ion/Li-Polymer battery.

Cut-off voltage

  • Cut-off voltage low. 2.7V for Li-xx battery.

Cut-off type

  • Cut-off soft, reduce the power when voltage drops to the cut-off voltage.
     

90A Max Current Burst.  No Bec need separate battery pack for receiver.
Net Weight :40g
 

 

Your IP Address is: 3.88.114.76
Copyright © 2024 XC-RC.com.au. Powered by Zen Cart